Free shipping for orders over $25!*No shipment to outlying areas

Système de filtration d'eau par osmose inverse Frizzlife RO - Filtre à eau RO sous évier à débit rapide 1 200 GPD, sans réservoir, réduit les TDS, compact, PD1200

Modèle: PD1200
Fast pure water in a compact tankless design

$1,099.00

Certificat

Testing performed under NSF/ANSI standards 42&53&58. This system has been tested according to NSF/ANSI 42&53&58 for the reduction of substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permittable limit for the water leaving the filter as specified in NSF/ANSI 42&53&58
Worry-Free Warranty
Acheter maintenant

Méthodes de payement

Livraison rapide et gratuite dès 25 $ d’achat.
Garantie gratuite d’un an (Inscrivez-vous pour bénéficier de 150 % de couverture)
Retour sous 30 jours – achat en toute tranquillité
Service client à vie
Payez en toute simplicité :
  • PayPal
  • American Express
  • Mastercard
  • Discover
  • Afterpay

Caractéristiques

Modèle
PD1200
Débit
0.83 GPM
Dimensions
6.1"L x 15.8"W x 18.3"
GPD
1200
Rapport de drainage
3:1
Sans ballon
Installation
No Installation
Drill a hole in the countertop
Électricité requise
Reminéralisation
Détails des certifications

NSF/ANSI 372
SGS Certified

Méthode de purification

0.0001um Reverse Osmosis
Activated Carbon+PP Cotton

Matériau

BPA-FREE

Manuel d’utilisation

FAQ

Why there are many white bubbles in the water?

Normally for the first time use of the RO system, the water seems to have white bubbles in it, which is normal and totally drinkable. it is because when the pump is pressurizing the water, it will pressurize the air at the same time. It will make the air molecules smaller, thus the solubility further increases. The air can' t be released at that time because ofthe pressure in the RO system. However, when you turn on the tap to get a cup of water, the pressure of air is released. So you will see a huge number of bubbles in the water. it looks cloudy and white, but they are just bubbles. After you put the water still for a while, all bubbles will be gone, the water is totally good for drinking.

Why TDS is higher at the beginning, but back to normal range after about one minute?

Osmosis is a natural phenomenon happens in all RO system, no matter if you have a conventional RO system or tankless RO system. When the RO system starts to work, pressure from the pump overcomes natural osmotic pressure. forcing feed water through the RO membrane that removes the impurities. When the RO system stops working, the pump stops offering pressure as well. At that time, because of different concentrations, a small fraction of ions will enter into pure water and cause TDS to rise by a small amount.
However, even if the TDS reading is a little high at the beginning, the quality water is still unbeatable by any other filtration methods including carbon, KDF, ceramic, UF UV, etc.. The water is totally good to drink and you don' t have to wait for about 1 minute to get the water, since the whole system will not release any harmfulsubstances to the water. The TDS removing rate for PD1200 is about 94-95%, if your incoming TDS is high, the outlet TDs will be high too.

How does the TDs display on the rachine work?

When the system is running, the TDS sensor in the PD1200 will keep testing the water quality every 30 seconds. Therefore, the TDS result you see from the machine is from the last test memory. If you want to have the real-time TDS result, please let the machine run for about 30 seconds.

Why the system does not work after connecting the power cord?

Maybe you have plugged the power cord into the socket specially designed for garbage diposal, please change another socket.

Vidéo d’installation

Avis

Frizzlife

Système de filtration d'eau par osmose inverse Frizzlife RO - Filtre à eau RO sous évier à débit rapide 1 200 GPD, sans réservoir, réduit les TDS, compact, PD1200

$1,099.00
Voir le produit
Copié avec succès !